No muss, No fuss!

A revolutionary new process that restores the finish coat of polyurethane on hardwood floors to like-new condition is now available. The FreshCoat Process is delivering extreme value to homeowners looking to make their hardwood floors look like-new again. For about 1/3 to 1/2 of the price of conventional re-sanding, FreshCoat will make most floors with beginning signs of wear look like brand new. Older floors will also be significantly improved, and in cases of extreme wear FreshCoat rescues floors from the grave. The 100% (that’s right, 100%) dust-free process is completed in just one day, and you’ll be able to use the floors after just two hours of dry-time!

Here’s how it works. Most hardwood floor owners know all about the everyday wear and tear from foot traffic, furniture moving episodes, excitable pets, children, and spouses. They know all about surface scratches, scrapes, dull or worn-thru areas in the high traffic paths, not to mention the trouble table and chair legs can cause. They know that sooner or later they will probably have to have the floors re-sanded, clean up a big mess and wish they had installed ceramic tile instead. Ask anyone who’s had their floors re-sanded and you’ll likely get a very colorful description of what a nightmare the re-sanding process can be. That’s why most folks wait until their floors are completely trashed before they call someone in for help. This is why the FreshCoat process was developed. To be the no-mess, low-cost, fast and easy way to revitalize and maintain the good looks your floor should have. Properly maintained, hardwood flooring is beautiful to look at, comfortable to the bare foot and easy to keep clean. Many hardwood floor owners complain that they just can’t get their floors clean no matter what they use. Fact is, many times what they are using to get their floors clean actually creates a build-up of soap or wax-like material that clouds the finish and absorbs (yes, absorbs) future dirt and everyday grime. Over time this built-up layer will look the same as if your floor had no protective finish at all. Re-application of these cleaning products further seals in the trapped dirt. Now what? Re-sand the floors? Not anymore! Now there’s FreshCoat!

The FreshCoat process starts by removing the built-up layer of cleaning products and everyday dirt, grease and grime from both the surface and unprotected areas of the wood grain. This is accomplished with an abrasive pad, on a high-speed buffer, in combination with a non-toxic chemical prep spray. The spray loads the dirt, grime, and even the wax-like materials into the abrasive pad which is changed as required to remove the surface contaminates. Once this step is completed the floors are so clean, you could eat off them!

Next, touch-up staining and other hand details are performed to correct deeper scratches and worn-thru areas, then the floors are thoroughly vacuumed. Now on to the coating step: Both residential and commercial grades of polyurethane are available (in Satin and Semi gloss levels to choose from). The commercial grade is wise if you don’t know the maintenance history of the floor or if you have lots of children/pet activity. In either case, the finish is water based, dry in two hours and at least twice as durable as the oil based finish most floors currently have. Start to finish, the process is usually done in about four hours.

The result: a nice, uniform sheen across the entire floor, no more scuffs or surface scratches, most every surface defect is gone. Back in business! Bottom line, FreshCoat will give your floors back their once like-new appearance without the mess or cost of re-sanding.

Before